MPC 60 What's your rear gain switch set at?

Share your knowledge on these two classic MPCs
 Reply Share on Facebook

What's your rear gain switch set at?

8
33%
16
67%
0
N/A
  • Total votes : 24
User avatar

By Humblestar1 Wed Jun 01, 2005 8:24 pm
Good thread MACCO

I voted....but i fear youth & apathy may hinder others!!!!

(C'mon y'all.....Vote BUSH out.....LOW GAIN LOW GAIN LOW GAIN LOW GAIN)

:roll: :roll: :roll: (there he goes again.....some one pass his medication pleeeeeease!!!)
User avatar

By butcher Wed Jun 01, 2005 8:33 pm
i think you had to much coffee this morning humble... :shock:


mine is set at mid right now... what about u el???
User avatar

By Humblestar1 Wed Jun 01, 2005 8:35 pm
butcher wrote:i think you had to much coffee this morning humble... :shock:


mine is set at mid right now... what about u el???


but i don't even drink coffeeeeeeeeeeeeeeeeeeeee :shock:
:shock: :shock: :shock: :shock: :shock: :shock: :shock:
User avatar

By butcher Wed Jun 01, 2005 8:36 pm
:shock: :shock: :shock: :shock: :shock: :shock: :shock: :shock:

redbull???
User avatar

By Humblestar1 Wed Jun 01, 2005 8:47 pm
Man...wotever it is.....or isn't...i need to stop it...or is that 'start it????

Help meeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee!

hey...maybe if i turn the gain up a lil on the em peeee.... Captain...its a long shot.....but it just might WORRRRK! :idea:

By elmacaco Wed Jun 01, 2005 9:13 pm
I have mine at mid, but I'm feeling like experimenting...
User avatar

By Something Like That Wed Jun 01, 2005 10:09 pm
mine stays at mid

By spectre Wed Jun 01, 2005 11:39 pm
djames wrote:
Something Like That wrote:mine stays at mid


ditto

By PerpetualNoob Wed Jun 01, 2005 11:52 pm
i'm the noobiest of the noobs and i set it at mid.

By peezie Thu Jun 02, 2005 12:09 am
i always had it on low ever since i bought the machine, but it doesnt seem to make that much difference. just have to crank the red knob a little higher.

By fobedafied Thu Jun 02, 2005 2:59 am
i have mine at MID, but sometimes i spend like forever messing with my source and input volumes before sampling... maybe i should experiment too a bit...

nice thread, id like to read more on this topic...

By goldenechos Thu Jun 02, 2005 3:41 am
I change mine depending on the kind of sample I am trying to get... the input gain on the 60 is pretty lo-fi and I find that the more of it that I use (instead of the clean gain from my board) the dirtier the sample. That input also overdrives very easily.

T
User avatar

By DJAndreas Thu Jun 02, 2005 5:42 am
Mine is on low
 Reply
Return to MPC3000, MPC60