fitting memory mpc 2000xl

how do i fit memory into my mpc 2000xl???

help......i got it now?

Take the bottom panel off (obviously). Tilt the memory card into the slot at a slight upright angle, and push it until it snaps into place (90 degrees).
Just make sure the notch on the bottom of the memory card is facing the correct way. Also, it doesn't matter which memory slot you put it in... the MPC will recognize it regardless.

that's a gangsta lean right thurrrrrrrrrr. do i need to be earthed or some sheeet?

Yes! I wouldn't try doing this on a dry non humid day on a thick shag carpet. No No NO! Static electricity will get you!!:lol:
If you got your memory in those static free palstic bags, keep it in there until you need it. Also, unplug your MPC and then press the "POWER" button just to short out any voltage stored in the circuits.

dun, thankyou, your help was well needed. cheers

No probs yo. Glad I could help!