Turning pads to Mono & Default Program

I would like to set all the pads to mono. Does anyone know how to do this? I also would like to save a default program so that everytime I load it I can have all the pads set to mono. It is not in the manual and I have looked everywhere for this answer. Please help!

if your using an mpc 1000 hit mode, program, then f3. go through and change all your pads, then save it as a program. put this program in your autoload folder.

I will try it, but I have an MPC 2000XL. Thanks. Anyone else? Please help!

After further iinvestigation I answered my own question. It can be found on page 121 Chapter 7 of the MPC 2000XL manual. Thanks!