Protools 7.0 and 2000xl sync question

I just upgraded to PT 7 and when I try to sync a loop my MPC will play once through the given number of bars. PT keeps looping but my MPC stops and then syncs back up at the beginning the next time the loop from PT starts. In other words, the MPC won't continuously loop with Protools. This is a new problem for me. I never had this happen with PT 6.4. I hope someone can help....Is it something I need to set in the MPC? or something in PT?

MPC 2000xl, MIDI clock sync In2
Digi 002
PT LE 7.0


ugh

Go back to PT 6.4 if you want it to stop.
PT 7/PT6.9/and PT6.7 (I think PT6.7 did it also can't remember).
Digi is aware of the problem, still you should go to the support page and send them the info to help keep them focused on the importance of fixing this.
We thought for sure that it would be fixed in PT7 and it wasn't.

Tech Support Request Form

That's very slack of digi. This crap is pissing me off! I don't wanna have to switch back to 6.4.