Printing template on custom pain mpc

I downloaded the mpc cover from: http://www.ghettobeast.com/mpccover.html

But all shops and companies i ask say that they can not make a film to spray on.

1 the letters are too small

2 how would you let the middle in a O or P hang. ?? not possible.

So you need printing it on , or

a film that works like a tatoo like those from cheewing gum, to print it on.

Can anyone help me?

Anybody who did this with succes.

THANKS

PEACE

i was thinkin about this myself thanx for the coversheet! what about going to a sticker company like the ones that make stickers for advertisements on cars?

1 - small letters can be a problem, but there is definately machines who can cut them out though

2 - first you make the template film, it would need to be an adhesive film so the middle in the letters dont fall off just by picking it up, then you put another adhesive film on top of the template so every thing will stick to that and then fixate it to the mpc, take of the layer that protect the adhesive on the template film, tape the template to the mpc and remove the second adhesive film... and there you go the template is taped to the mpc

does it make any sense??

Chulukinat wrote:i was thinkin about this myself thanx for the coversheet! what about going to a sticker company like the ones that make stickers for advertisements on cars?

usually they don't make films with letters that small but they might have other cool films like 'holographic' or reflective or glowing the dark type of films which could look cool on an mpc