MPC doesn't ouput program changes after OS upgrade

I upgraded to 2.1 and now the MPC won't output my program changes to my other gear. Any idea?

Jay

it happened to me also. i had to dig the manual for this one

basically it is disabled per track by default.
so in the main screen, you scroll through all your programms until you reach one which say No: 1
then press "window", and here it is: "transmit prog. change in this track"

then you can even put the program back to anything (off, or whatever), the setting is kept.

it's always after I write something is when I figure something out. If you select pr. no.1 and hit window, the option comes up to activate program changes.

thanks man. You beat me to it.

haha clock same here...but hey, at least you're helping the masses w/ your own mistakes right?

the new os changed some general workflow things....old stuff must be reconfigured...not really a problem...

i get stumped here and there by a couple new bits and pieces but on a whole i think it all makes sense and haven't really looked at the manual yet.

again, ppl, please read the manual. with so many changes some of what you were used may not be the same.

this is in a sense, a new machine.