problen with step edit ..?

I cant see anything in step edit mode, it seems that theres nothin.. but there should be, the song still plays normally, and when i roll down a sequense whit step key i can hear a sound when it hits it, but theres nothing there? This started when i copied a sequense, then i wondered why there is nothing in there and then i realised that its same with every sequense. I turned my mpc2000xl of and loaded the song and sounds but same thing still. View: ALL EVENTS is on. ???

Hello Andy,

Resolved your problem is quite simple check out the 1.14OS for 2KXL, on Akaipro site!!!

Big up! and take care.

Hello Andy,

Resolved your problem is quite simple check out the 1.14OS for 2KXL, on Akaipro site!!!

Big up! and take care.

Hello Andy,

Resolved your problem is quite simple check out the 1.14OS for 2KXL, on Akaipro site!!!

Big up! and take care.

You'l only see something in step edit if there is something at that particular event (time)

What you should try is to program some str8 16 hats (1bar) on track one.
Go into the step edit screen for that track. Make sure the VIEW: is set to ALL EVENTS

You should see the 1st hat @ 001.01.00 >>>>Use the STEP keys/ Cursors to jog along to the next hats programed in at 16ths

See anything now?

I can set new sounds in every sequense ,and see them too. But still i cant see the old ones, i can hear them but not see. VIEW: is ALL EVENTS.
And when i try to scrol it whit event button it goes rigt to end of that sequense, so its like their no there but still are somehow?
I've been working whit this song for quit a while now, and suddenly when i copied a sequense it stardet this??

Are they in the original Seq?

yep they are (Or what do u mean by "original seq") ?

your on the right track that the sound is on. Example, if your in step edit, and your looking for your kick drum, make sure your on the track that the kick is on, or you will hear it, but not see it.

. ..roxstar. ..
http://www.soundclick.com/creamofbeats

wow.. thats it... theheh thanks for your advises.

You'l only see something in step edit if there is something at that particular event (time)

What you should try is to program some str8 16 hats (1bar) on track one.
Go into the step edit screen for that track. Make sure the VIEW: is set to ALL EVENTS

It was right there in ya face all along

thanks fellas,i was having some problems with this also

...must admit, I had the same problem a while back.

me too, it isnt something you really think about when you're in the heat of the beat mane.....

You do not have to program right on TC values to see them in Step Edit. Just hold shift and Press < or > while in step edit to move to the next event (just like it shows right on the front of the MPC!) . You old salts should know and mention this.