how to remove the slider

charles p wrote:ok so if i want to check my 8 outs connections...I open the bottom or the top of my mpc ??

This was already answered:

mnh2410 wrote:If you have the XL remove all screws on the bottom.

If you have the 2k...

3 in back
4 on side
3 on bottom lip(where floppy is)
3 once floppy bottom lip is removed
4 on the side once front case is removed
Then remove the controller board(2 screws)(knobs, buttons, ect. is)

charles p wrote:ok so if i want to check my 8 outs connections...I open the bottom or the top of my mpc ??

I highly recommend u DONT try to repair it yourself. If you dont know how to take it a loose do u think u know how to check the 8 outs. Im jus wondering. If u stayed close i could help you out, i could prolly fix it with no problem.

mnh2410 wrote:

charles p wrote:ok so if i want to check my 8 outs connections...I open the bottom or the top of my mpc ??

I highly recommend u DONT try to repair it yourself. If you dont know how to take it a loose do u think u know how to check the 8 outs. Im jus wondering. If u stayed close i could help you out, i could prolly fix it with no problem.

you are right i dont know how to fix that...but maybe just a wire is disconnect ? is this possible ?

I dont think I stayed close of you, im from canada. maybe you can help me online, on this forum, or maybe on msn [email protected]

thanks a lot

charles p wrote:you are right i dont know how to fix that...but maybe just a wire is disconnect ? is this possible ?

Well the board has one big wire so i doubt its the wire. It may jus be a shortage but you could try uninstalling it and then re-installing it. That may help.