By robertG
Mon Apr 10, 2006 3:29 pm
I have sampled a load of sounds and I want to assign them to pads but I cant see a option in the manual and cant work it out either
By Smoove03
Mon Apr 10, 2006 3:31 pm
in PROGRAM MODE, hit the pad you want to assign a sound to and scroll to the sound you want on that pad.
By enotide
Mon Apr 10, 2006 3:36 pm
Read Chapter 7 that should help.
Even if it's jazz or the quiet storm
I hook a beat up convert it in a hip-hop form
http://soundcloud.com/enotide
http://blend.io/enotide
I hook a beat up convert it in a hip-hop form
http://soundcloud.com/enotide
http://blend.io/enotide
By robertG
Mon Apr 10, 2006 4:00 pm
I am holding down shift and program (No 6)
I then get a screen saying "please select a drum program to edit
drum 1, 2, 3, 4 I hit 1 and get to the assign page i go to pgm and roll the data wheel
but this has no effect, or when i assign their is no sound
so far I have sampled a brass section pluss BD SD HH OH and some od bits & pieces,
I cant quite figure out from the manual page 113 what I am doing wrong
I then get a screen saying "please select a drum program to edit
drum 1, 2, 3, 4 I hit 1 and get to the assign page i go to pgm and roll the data wheel
but this has no effect, or when i assign their is no sound
so far I have sampled a brass section pluss BD SD HH OH and some od bits & pieces,
I cant quite figure out from the manual page 113 what I am doing wrong
By robertG
Mon Apr 10, 2006 4:10 pm
sorted it! everything in the mpc seems back to front. I am slowly getting the hang of it!
By Smoove03
Mon Apr 10, 2006 4:11 pm
are you hitting the PAD that you want the sound on BEFORE you choose what sound you want on that pad? may not be the same as the mpc 2000, but im sure its similar