MPC 60II Question from newcomer!

hey
first off i gotta say - this is a seriously wicked forum, so many unanswered mpc 60 questions are now sorted and i've finally managed to carry out some diy repairs on my fave drumbox - so big thanks to all contributors..

anyway, i'v recently landed an mpc 60II very cheap in the UK, but it's totally shot to shit - firstly the backlight was totally gone.. i managed to get one off a Canadian dude on ebay -it's an S1000 and MPC60II model (i think he's sitll selling them on there)- read the thread on fitting a new display; seemed simple enough - gone about doing it, but no luck at all.. i'm running software 3.02 and it's a slide-in display- but just can't get any light outta the damn thing..

if anyone has any ideas would greatly appreciate any feedback!
thanks
Sharooz

You have installed the backlight correctly and it´s not working?
Maybe you did not fully solder the contacts of the display, or the cables don´t get power.

thanks for the advice dude but i've checked and double checked the solder contacts, but still no luck...

Did you take time to determine if the original backlighting was bad?
Sounds to me like it maybe wasn't and you had a voltage supply problem causing the original to not work.
Try to get a service manual or instructions on checking the inverter and display.