Post your views and questions about the Akai MPC2500
By msolay Sun May 14, 2006 6:03 am
So i just turned on my mpc and after it flashes the 128 mb installed it goes right to a screen that just says SYSTEM TEST. It's been on that screen for about 20 minutes. I shut it off a bunch of times to see if it will just go away but now i have left it and it won't go away. Man this is wierd.
User avatar

By cre8tive Sun May 14, 2006 7:59 am
remove and reinstall your ram and it should work again.
User avatar

By Spirez Sun May 14, 2006 10:03 am
You might also want to try a factory reset, i think you hold erase when you turn it on.

Check the manual though, i've never done it
User avatar

By jahrome Sun May 14, 2006 11:53 am
msolay, what RAM did you install in your MPC?

By msolay Sun May 14, 2006 3:41 pm
my ram came preinstalled from vst service.

By msolay Sun May 14, 2006 4:54 pm
i just took out my ram and reinstalled it. I turn the Mpc on and it still says SYSTEM TEST. I don't know what to do. Does anybody have any more ideas?
User avatar

By Spirez Sun May 14, 2006 5:04 pm
Did you try a factory reset?

By msolay Sun May 14, 2006 5:08 pm
i turned it on and held erase for about a minute and nothing happened. Is that how you do a factory reset?
User avatar

By Spirez Sun May 14, 2006 5:12 pm
I'll have to find my manual to check
User avatar

By Spirez Sun May 14, 2006 5:24 pm
01. Turn the MPC2500 on while holding the [ERASE] key.

02. Release the [ERASE] key after the display shows [
MPC2500 (##MB installed)].

Now the MPC2500 is reset to the Factory Preset settings.

The following global settings are stored in the
MPC2500 :

Timing Correct (Note value, Swing%)
Click/Metronome (Count in, Rate, In play, In rec)
Step Edit Options (Auto step increment, Duration
of recorded notes)
Active track receive channel
Soft thru
Sync in
Sync out
Master level
Sustain pedal to duration
Truncate duration
Tap average
Footswitch 1
Footswitch 2
Autoload
LCD contrast

Doesn't sound like it's gonna solve anything i'm afraid. Have you tried removing the RAM completely and then booting up to see if that helps?

By msolay Sun May 14, 2006 6:07 pm
i just took out the ram and turned it on and it still says system test after it shows the ram. What the hell is going on with this thing?
User avatar

By Spirez Sun May 14, 2006 6:35 pm
Hmmm, not too sure what else to suggest. Have you called VST?

By msolay Sun May 14, 2006 6:37 pm
i'm going to call them tommorow because they're not open today.
User avatar

By jahrome Sun May 14, 2006 7:04 pm
That's your best bet. I am pretty sure they will quickly swap you out with another MPC if there is a problem with yours...

By msolay Sun May 14, 2006 8:30 pm
can they save my memory in my hardrive if this thing is screwed?