Anyone personally replace 3000 side arms

Share your knowledge on these two classic MPCs
 Reply Share on Facebook
User avatar

Anyone personally replace 3000 side arms

By Tal Tue Jun 06, 2006 3:26 pm
My replacement side arms are coming in a few days. Anyone personally replace them? speaking with bruce forat dude said its a simple job. But it does require the lifting of the board. said its easy but for a pro like that dude it should be. anyone have any useful advice
User avatar

By Tal Tue Jun 06, 2006 4:44 pm
mnh2410 wrote:http://www.mpc-forums.com/viewtopic.php?t=42694&highlight=side+arms
http://www.mpc-forums.com/viewtopic.php ... =side+arms

search term used:side arms

Nicole


appreciate the response nic but, those didnt lead me anywhere helpful.

By peezie Tue Jun 06, 2006 5:01 pm
you have to remove some screws on the bottom and the rear of the mpc. the bottom ones run along the side edge, parallel to the side panels. unscrew 4 on each side. then remove the 4 screw running along the top edge of the back of the mpc. all the screws are the same so dont worry about which goes where. it should be self explanatory from there. screw holes strip easily, so be careful.
User avatar

By Tal Tue Jun 06, 2006 6:10 pm
peezie wrote:you have to remove some screws on the bottom and the rear of the mpc. the bottom ones run along the side edge, parallel to the side panels. unscrew 4 on each side. then remove the 4 screw running along the top edge of the back of the mpc. all the screws are the same so dont worry about which goes where. it should be self explanatory from there. screw holes strip easily, so be careful.



no doubt. gonna put my reading glasses on for this one. looking to pc monitors for the last few years has left me blind
 Reply
Return to MPC3000, MPC60