mpc2000xl Tech Support

I hope Im not doing something against the rules when i'm asking about schematics for the mpc2000xl. My mpc2000xl burnt all audio output ic's when it was connected to a console with a "live chassis". I don't want the whole schematics, just the analog output board and the power supply board. Although I need to know what value resistor is R1 on the main digital board, the one on my board is a little bit cooked and is unreadable. If I couldn't get these schematics, at least somebody can tell me the output voltages on the power supply:V1, V2, V3. My boards -12 V is not right, I think R1 is responsible for the that. Anyone??

Go to AKAI Pro and call em. I think you might have to send it in.

I can hook you up with the needed info. Send me a PM or find my email at midicase.com

I measured the -12 power supply ok, the problem is R1, I removed it and measured it open. I'm going to install a 10 ohm 1 watt resistor to replace it. R1 is set as current limiting resistor connected to the -12V source coming from the power supply and acts as a fuse to protet the machine from worse damages on an event like mine. If R1 wasn't there i could also have a bad power supply. Anyone???

and while you're at it, do you think you could tell me how to install the Flux Capacitor Drive upgrade, too?
Thanks chief..

Swissmaster Cheese wrote:and while you're at it, do you think you could tell me how to install the Flux Capacitor Drive upgrade, too?
Thanks chief..

I just got mines yesterday.

remember to get the 16 kilowats plutonium or those flux capacitors wont work.

NOOOOOOOOOOOOOOOOOOOOOOOOO! MY SHITS Gonna explode!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!