Saving GO2MIX

I've made a beat on my MPC1000 and I thought that two of the samples were too loud so I went into the GO2MIX and turned them both down so they sound right. But every time I turn it off these are the only settings that don't get saved.

I read through the forum and thought I found an answer. Someone said to 'Save entire memory' instead of 'save all seqs and songs'. But I tried this and it didn't work.

I've looked through the manual and I can't find an answer either.

If anyone has any info that would be great.

andytlr wrote: Someone said to 'Save entire memory' instead of 'save all seqs and songs'.

thats good advice, give it another try.

make sure the overwrite samples is switched to yes , i had this problem but seems ok now i think i wasnt seitching this to yes at first

I'll give that a go when I get home from work. Thanks.

yea..that same thing was happening to me,,,You also lose all your effects if you dont do it this way,,
first create a new folder using the cursor, then move into the folder, THEN do the save all thing...This way next time you wanna load the beat, just select the folder, and you can load the entire beat all at once....its saving me HELLA time..

Makes it easier to load everything but it means you have multiple copies of samples. But I suppose it is just going to have to be like that.

Still not home but presuming it will work, thanks.

Yeah setting overwrite samples to yes when loading it back up worked.

Thanks