By jahrome
Fri Sep 29, 2006 11:16 am
megatron1904 wrote:
to reattach the carbon piece you don't even really NEED to solder it, you can just open up yer machine, pull the pads up and use scotch tape to hold down the carbon piece. I did this and it works fine. I actually ripped a pad off and scotch taped that back in too... pretty janky, but if you want it done real quick- it works. then play samples on full level and adjust in mixer. even better plan would be to get some aluminum tape and use that over the black piece underneath the pad.
Do all of that every you spent $700?? Shite...where can I purchase Akai stock..because yall will purchase anyting
Tool Box: Nuendo 4/MPC 2500/Reason 4/Emulator X2/Battery 3/Wave Lab 6