Post your views and questions about the Akai MPC2500
User avatar
By fantom27 Tue Nov 21, 2006 12:10 am
Perhaps a naive question.....But I've searched and I can't find the answer...

After upgrading the os, it's recommended to re-format the internal hard drive...

The format screen only allows me to format the memory card...??

How do I format the internal hard drive?

Jeremy

By shrednar Tue Nov 21, 2006 12:49 am
Did you bother to read the manual?
User avatar

By Upright Tue Nov 21, 2006 1:23 am
The area that says Device:MEMORY CARD change it to Device:HARD DISK :D
User avatar

By fantom27 Tue Nov 21, 2006 2:01 am
Dude.....I'm not that stupid.... :-)

I cannot select the hard drive....

It says device: memory card

I cannot change it to "hard drive".....the wheel won't change it.....the arrow buttons won't change it......


I pressed "mode".....PAd 2 (LOAD)......F3 (utility).....then it says device :memory card.......I cannot change it to hard drive........


Is there a memory protect function that I need to overide?

By Mike Feedback Tue Nov 21, 2006 2:07 am
here's a stupid question, do you have a hard drive in there?
User avatar

By Upright Tue Nov 21, 2006 3:27 am
Sounds like your drive may not be inserted in fully.
User avatar

By fantom27 Tue Nov 21, 2006 3:40 am
I'm gonna check that and then check another drive...This one is not showing up at all....

I have a 3000, 2000,2000xl,and a 4000, so my friend just brought me the machine to have a look, figuring I was the akai guy.......

He now tells me the drive came from a raid array in an old PC......I'm gonna check the jumper settings.

Thanks......
User avatar

By Upright Tue Nov 21, 2006 4:01 am
I believe another guy in these forums had a similar problem with a drive he got out of an old laptop.....more than likely it's the HD. :D
User avatar

By dablunt Tue Nov 21, 2006 5:12 pm
[quote="fantom27"] my friend just brought me the machine to have a lookquote]


that was nice of him.

sounds like it could be jumper settings - it is an IDE disk isnt it? not scsi.

i guess it would have a different connector if it were scsi tho.
User avatar

By selecta jo Tue Nov 21, 2006 5:35 pm
it is recommended to remove all jumpers from the hdd...
the mpc does not need them (no master/slave situation, no problem with hdds over 32gb size)...
also check if the hdd sits firmly in the hdm-10 adapter and the whole package connects good inside the mpc...
maybe the drive is faulty if it is somewhat older. always decide wisely if you want to save a few bucks on such a device when the possibility to get errors or lose samples and songs is getting up...

peace jo