A few 60 N00b questions

Share your knowledge on these two classic MPCs
 Reply Share on Facebook
User avatar

A few 60 N00b questions

By MC Denzel Washington Sat Dec 09, 2006 3:26 am
Hey I just got my 60II, and I have a few things I can't figure out...

1. How do you change the number of bars in a sequence? I know it's probably a stupid question, but the cursor won't highlight it to change it.

2. How do you get the sample to play just as long as you hold the pad?

3. How do you know if you have the ram upgrade? (it will only let me sample up to 13 seconds..so it doesn't have it, right?

Thanks in advance, sorry if these are real obvious :cry:

Re: A few 60 N00b questions

By Deta!L Sat Dec 09, 2006 5:10 am
MC Denzel Washington wrote:Hey I just got my 60II, and I have a few things I can't figure out...

1. How do you change the number of bars in a sequence? I know it's probably a stupid question, but the cursor won't highlight it to change it.


Edit>add or delete bars..loop to whatever bar you want it to loop to

2. How do you get the sample to play just as long as you hold the pad?

off the top, might not be right, sounds>2>note off

3. How do you know if you have the ram upgrade? (it will only let me sample up to 13 seconds..so it doesn't have it, right?

just go to sample section and see how far it goes up, at 13 you don't have the upgrade

Thanks in advance, sorry if these are real obvious :cry:

By kwality Sat Dec 09, 2006 11:45 pm
I think to change the number of bars in a sequence you can go to Delete-initialize and then change it to the number of bars you want.

Is that what you meant? That's the way I do it, and it seems to work well.
 Reply
Return to MPC3000, MPC60