PC to MPC HD

Hello, I'm trying to transfer all the samples on my computer where I previously stored them, to my 80GB internal hardrived that is installed in the MPC. When I transfer them to my MPC harddrive, they show up in the MPC window tray on my computer as being on the MPC hard drive. When I go to the MPC and the "mode load" option and scroll through all the samples on my hard drive only about a fourth of them are showing up. All the samples are catigorized alphabetically on my PC, so when I scroll through the samples via the MPC I only see the samples begining with A - F. I have no where near 80GB of samples loaded, so why am I unable to see the remainging samples? I'm not actually loading them to programs, just scrolling through the hard drive.

the mpc only reads 16 bit 44100 khz

All the samples are formated at 16 bit 44100 khz. When I go back and delete one of the samples from the hard drive, one of the other samples that previously could not be seen in the scroll list, will then show up.

That's not good. Was this drive formated with the MPC?

yeah it was formatted....

...with the MPC?

yeah

put your samples in individual folders...like all samples that start with "A" are in a folder named "A"...all samples that start with "B" are in a folder named "B" and so on. try it with some of the samples that aren't being displayed first to make sure it'll work before you spend the time to do all your samples.

^^good idea