Changing Programs When Ram is Full

Hi, I've just brought brand new 2500, everything is sweet and is a dream to use!! One question....

I have loaded all my programs in and filled up the 128mb ram, how do i remove a program so i can replace it with a different program?

If possible can i make folders that are 128mb (long audio samples) on my hard drive, and swap and change these as i need throughout a set?

Thanks

128mb of samples loaded at one time?
I would be too afraid of the way that may make the 2500 run.
If you make folders you can do the load all where it clears the memory and loads everything that's in the folder.
If they are all loaded in the MPC you can save the entire memory to a folder, then just load that folder.

Just load another program, and press "CLEAR" and it will remove your old program and load the new one.

Thank heaps its working a treat!!

yup, you're welcome.