filter all the pads at once

Post your questions, opinions and reviews of the MPC1000. This forum is for discussion of the OFFICIAL Akai OS (2.1). If you wish to discuss the JJ OS, please use the dedicated JJ OS forum
 Reply Share on Facebook

filter all the pads at once

ByRAYGINGBULL Tue May 04, 2004 2:57 pm
how do u filter a program or all the notes at once?

By TerroristProphecy Tue May 04, 2004 3:12 pm
wonder if you can? be good if u could..

Re: filter all the pads at once

By tritone Wed May 05, 2004 2:38 am
RAYGINGBULL wrote:how do u filter a program or all the notes at once?


There are two global 4-band EQs on the FX 1/2 pages... and another 4-band EQ on the Master Effect page... but no global Low Pass Filter or any such. Have to go to an external filter box for that I think.
User avatar

By freezerman Wed May 05, 2004 4:38 pm
there seems to be no batch processing options for programme parameters in the mpc1000.

no filter control, no envelope settings control, no polyphony control, no mute groups etc....

can be quite annoying sometime (set all samples in a programme to same mute group to make a monosyth type of programme, or reset all filters to off etc...)
User avatar

Re: filter all the pads at once

By djadonis206 Wed May 05, 2004 4:39 pm
RAYGINGBULL wrote:how do u filter a program or all the notes at once?


ReSample your seq and then run your filter over your newly created audio file

{MODE} record - main outs (turn the volume all the way up) - trim your loop - assign it to a pad - assign a filter to your sample - filter away

Re: filter all the pads at once

By TerroristProphecy Wed May 05, 2004 10:13 pm
djadonis206 wrote:ReSample your seq and then run your filter over your newly created audio file

{MODE} record - main outs (turn the volume all the way up) - trim your loop - assign it to a pad - assign a filter to your sample - filter away


nice tip
 Reply
Return to MPC1000