5.42

---------------------------------------
Change : Ver5.42 07-Nov-2007
---------------------------------------
1.[TRIM]
AFTER Key1+Q1-Slider1-> Change Start point./Change Loop point
AFTER Key1+Q2-Slider2-> Change End point.

It changed as follows.
AFTER LED OFF:dose not work.
AFTER LED ON :work.
Q1-Slider1-> Change Start point.
Q2-Slider2-> Change End point.
Q3-Knob1-> Change Loop point

Alright.....finally a JJ feature that I actually need. I guess I will stop talking sh!t about JJ....at least until I find a bug that is a show stoppa

ok

BRING BACK PAD MODE!!!!!!!!!!!!!!!!!!!!!

damn 5.42 already
i'm still on 5.30
thx for the update news

bring back pad mode ?

YES! PAD MODE!!

`TK wrote:bring back pad mode ?

Were you able to change sequences with Pad Mode? What were all the functions you were able to assign to a pad? I remember messing around with it and was searching for the other day. This explains why I couldn't find it. I needed to be able to change sequences with the footswitch.

Yeah, I need Pad Mode. I'd gladly give up some of the sample editing tools in Trim since I use my computer for chops and that sort of thing. Bit Convert should stay though...

Pad mode is where it's at. Plus the new mute functions are retarded (in a bad way).
I'm staying with 5.36.

King_Vitamin wrote:Pad mode is where it's at. Plus the new mute functions are retarded (in a bad way).
I'm staying with 5.36.

Does anyone have 5.36?

pm me with an email.

i have all versions except 5.15 and 5.25 available here: http://www.mikefeedback.com/MPC2500/

if anyone has 5.15 or 5.25, let me know.

Mike Feedback wrote:i have all versions except 5.15 and 5.25 available here: http://www.mikefeedback.com/MPC2500/

if anyone has 5.15 or 5.25, let me know.

Awesome! Thanks guys.