Any way to change the velocity of "full level" mode?

I wonder cause last night when I tried to control a rhodes vst with my buggy fukai 1k pads, I couldn't play without full level mode because some of my pads are f*d up. The full level velocity is 127, I would like to have possibility to change the velocity cause when you hit 127 a vst synth its too hard.

Anyone understand me?

I don't think there is...

you could sequence a part, all pads at full level, then just go into step edit mode and change the velocity through there

AFTER+qlink - note on - velocity - track

then you don't even have to hit full level, just select your velocity via qlink and play.

Antonym wrote:AFTER+qlink - note on - velocity - track

then you don't even have to hit full level, just select your velocity via qlink and play.

dope

Antonym wrote:AFTER+qlink - note on - velocity - track

then you don't even have to hit full level, just select your velocity via qlink and play.

Thank you!!

this one is a very good tip. thanks.
esp. with the faulty pads most of us have around here....