By synthbob
Tue Nov 27, 2007 12:37 pm
Hi Everyone,
Just had a lovely experience....playing live some out of it raver managed to knock our mpc off a 3 foot table onto the floor. Its not looking too bad but the master volume knob took a beating and is now wobbly and crackly.
I'm decent with a soldering iron and recon the pcb its connected to needs a look.
Before I have a go, has anyone here taken their's apart? Anything I should be careful of trying to get to the back of the volume pot?
Cheers if anyone has advice.......
R
Just had a lovely experience....playing live some out of it raver managed to knock our mpc off a 3 foot table onto the floor. Its not looking too bad but the master volume knob took a beating and is now wobbly and crackly.
I'm decent with a soldering iron and recon the pcb its connected to needs a look.
Before I have a go, has anyone here taken their's apart? Anything I should be careful of trying to get to the back of the volume pot?
Cheers if anyone has advice.......
R
