Save config of PAD on MPC 2500 OS JJ

Hello,

I have configured my 16 pads (MIDI) to control my Machinedrum (Elektron gear). I would like save this config to avoid having to config pads every time that I start my MPC.

How can I do this ?

Cheers,
Vincent

You create a Program and then map the pads how you need them to be.
If you save the Program it will save the map for the pads.

Ok, thank you ...

Ok, I use the MPC only as a midi sequencer. No sample.
I assign different notes to the pads (Ex : PAD 1 = C1, PAD 2 = D2, ...), I make this to control my machinedrum and create the beat with the MPC.

I save the sequence on my card but I can't save the config of the pad. When I put on my MPC and load the sequence, I must re config the PADS, each time I start the MPC.

Can you help me ?

Cheers,
Vincent

You create a Program and then map the pads how you need them to be.
If you save the Program it will save the map for the pads.
Saving the Sequence isn't what's important it's creating the Program and saving the Program since that's the actual template.

I followed your instructions but when I load my saved program, nothing is config like I did.

PM me your email address and I'll send you a PGM to load and see if it redoes your pads.

Digital Network wrote:I followed your instructions but when I load my saved program, nothing is config like I did.

After you reload the program you saved you have to make sure you turn to that program on THAT SPECIFIC TRACK!

coles_brandon wrote:After you reload the program you saved you have to make sure you turn to that program on THAT SPECIFIC TRACK!

Yes I do but nothing.