Post your questions, opinions and reviews of the MPC1000. This forum is for discussion of the OFFICIAL Akai OS (2.1). If you wish to discuss the JJ OS, please use the dedicated JJ OS forum
By BennyDigi Sat Dec 22, 2007 11:14 am
I need to backup my hard drive to upgrade the OS but can't figure out where to dump all the data. Please help me out.
User avatar

By cozy Sat Dec 22, 2007 2:03 pm
dump it into a new folder on your desktop through usb.

By BennyDigi Mon Dec 24, 2007 8:57 pm
I got it.. What a stupid mistake on my part. Thanks.

By DJ Finyl Tue Dec 25, 2007 9:00 pm
to be honest... you don't have to back up for the new os. all it does is write onto the card not rewrite the card

By BennyDigi Tue Dec 25, 2007 9:14 pm
Yea I figured that out after the upgrade. I just wanted to be safe and not loose all my stuff.
User avatar

By elektrik_muz Tue Dec 25, 2007 9:18 pm
If it was formatted with the Akai OS to begin with, then yes it does need a reformat. Unless yer the type that doesn't care about write errors causing data corruption due to the faulty Akai format routine.

By infinityler Mon Jan 26, 2009 3:08 pm
I have a mac book & it won't recognize the MPC hard drive. It will recognize the CF card, but not the HD itself. any suggestions?
User avatar

Re:

By hiphoppa Mon Jan 26, 2009 4:53 pm
infinityler wrote:I have a mac book & it won't recognize the MPC hard drive. It will recognize the CF card, but not the HD itself. any suggestions?



Power off the Mac, power off the MPC. Use a different USB port and power up the Mac then the MPC. Should go in.

Good luck, let me know the results.

By infinityler Tue Jan 27, 2009 1:32 am
Yeah, I restarted both systems & it works fine now. I should I worry about the jiggly USB port on the mpc? Thanks
User avatar

Re:

By hiphoppa Tue Jan 27, 2009 12:46 pm
infinityler wrote:Yeah, I restarted both systems & it works fine now. I should I worry about the jiggly USB port on the mpc? Thanks



Of course, you'll have to be careful when placing in the usb to the mpc. If your machine never leaves the spot then you can leave it in, that's what I do. but you could take it to an electronic repair shop (tv repair and such) and they might to help.

Is this a used unit? If not take it back...

Good luck,

xPEACE