Loosing my mind over this step...I need a complete run down

I have the MPC 1000 and was told that if I chop my samples on a PC, I would have to create a new program. Well, I did so using "Blue Box" but after I transfer the program to the MPC, I hit the pads and nothing plays...why is that?

I use Adobe Audition 1.5 to cut up samples. It's more accurate to cut sh*t up on a Computer >I Think<... After I finish up I transfer each sample to my MPC1000 as a wav. file! Then I assign each sample to Pads On B Bank! Maybe I'm not understanding the question!

Better yet... Maybe I don't even have the authority to answer questions... Buahahahahahaha!

Beat Fanatic wrote:I have the MPC 1000 and was told that if I chop my samples on a PC, I would have to create a new program. Well, I did so using "Blue Box" but after I transfer the program to the MPC, I hit the pads and nothing plays...why is that?

Because you have to load the program into the RAM memory and then go to the bottom of the screen where it says PROGRAM and select the program you just made..... THEN, you will be able to hear it.

Thanks man

if after all that you still hear nothing, try switching your output plugs in back, some times you can have your mono coming off the right output but plugged up to the left therefore not being able to hear anything.