jumper settings for the disk drive

i took out the disk drive to use in my emax. i no longer use the emax and want to put the disk drive back into my xl. anyone know the jumper settings for it? a picture would be helpful.

On every internal Zip drive the settings are the same -- far right of the three jumpers. Unless you need it set to primary master, in which case I do not know.

not sure what you meant by that (far right of the three jumpers)...

found this pic in the mpc 3000/60 forum and my jumpers are set the exact same way. my floppy drive is the same model too. if you think you can just circle where the jumpers should be that would be good.