sequences overlapping

Good Afternoon All,

a quick question, when i set my sequences up in song mode, one of my sequences leaks into the next one. how do i prevent this as before i went into track mute and setting one shot to immediate and it worked, however this time it isn't.

the sample leaking is a one shot of a flute.

advice appreciated.

if its os2 yor using it might because one shot sample behave diffently when loop is
turned on . check the sample in the trim scren or mess with adsr end:off settings.

http://www7a.biglobe.ne.jp/~mpc1000/os2/adsr_amp_e.htm

im using os1 4.99, im pretty sure the sample isn't set to loop but will double check when i get home. cheers for the help.

it wont be that then cause one shots dont loop in os1.
i might test it myself later if i get time.

are your samples set in a mono program? just coz if theres a sample right at the start of the sequences, then they will cut out any leakage from the last sequence's last sample. Or if you dont want to set the program to mono, and/or a sample isn't placed at the very start of the sequences, maybe just set the leaky sample to note on, and record it again to let it off where you want.

all the samples were set how they needed to be, i jus re-record the 2 seq's last night and it plays fine now. very bizarre.

cheers for the response none the lesss.