Adat Board problems!!!!

I currently have the 8 out expansion for my 4000,and I'm trying to install the adat expansion. I won my board on ebay so I dont have any instructions. I installed the big ribbon by the hard drive as I read in an earlier post. I still dont know what to do with the green wire though. My 4000 is showing that the Adat card is installed on the global page,but it's not showing up on my mix page. I flipped through the outputs but,it's just showing the regular eight outs.

Those are the same.. According to a fella MPC'er you'll only can have a max of 10 individual outs. So everything thats routed thru out 4-5 goes thru ADAT 4-5 and analog out 4-5.

Maybe it's my Digi001 one then. I'm not getting any sound when I try to route my 4000 to my Digi.

Where does the green wire go

I figured it out! My Digi001 wasnt configured to recieve Adat input. I love this board

Make sure your bitrate and samplerate are the same on both 001 and 4k! Otherwise uo'll get crack and pops in PTLE.

The green wire connects to the IB4D option board. The IB4D being the digital I/O

sup,

theres a lil bit about the adat in this if that helps?


http://www.akaipro.co.jp/jp/datalib/dow ... Inst_E.zip