4k not doing its thing at 96k?

I can't get any audio or clock anything to the ADAT output on the MPC4k to
96k, only to 44.1k. My hammerfall multiface and Eventide eclipse should both
be able to clock to 96k. Cables and i/o settings all correct. Any ideas?

Richard

did you try to go to "Global" mode
then change the system clock to 96kHz ?

then it does an automatic reboot and it's all good

I do have it set properly but can't get it to output any audio via ADAT when its set to 96k. 44.1 works fine - nobody else had this problem?

richard

yo Rich, da 4K can't do 96kHz via ADAT, only via SPDIF, me thinks.

not an answer to your question but peep the last page or 2 on
http://www.mpc-forums.com/viewtopic.php?t=12975