problem? bug?

Technical questions for the MPC2000xl and the MPC2000
 Reply Share on Facebook
User avatar

problem? bug?

By eastcoast121 Thu Oct 09, 2008 10:04 pm
yo aite so i have a sample right, u kno when ur in trim screen and you hit shift+cursor u can get the job done faster. Whenever I do this on the end point, sometimes it jumps the end close to the beginning without the touch of the wheel. does anyones else machine do this? is there somethin that makes this happen?
User avatar

Re: problem? bug?

By DJ Hellfire Thu Oct 09, 2008 11:00 pm
If you have an XL, the variation slider took a dump. Mine has the same problem. Just apply a little pressure to the knob while you slide it (no homo), and let go of the select button before you relieve pressure from the slider. That's how I work around it. Or just buy a new knob!
User avatar

Re: problem? bug?

By Lampdog Fri Oct 10, 2008 6:05 am
DJ Hellfire wrote:If you have an XL, the variation slider took a dump.
User avatar

Re: problem? bug?

By eastcoast121 Fri Oct 10, 2008 7:26 am
im not talkin about the slider. im talkin about when you hit select then the left cursor key. sometimes when i do this on the end feild it jumps the end way far up, near the start of the sample, sometimes i dont even have to hit the cursor buttons, if i hold shift for like 3 seconds itll do it.
User avatar

Re: problem? bug?

By Jacpot Fri Oct 10, 2008 11:04 pm
eastcoast121 wrote:im not talkin about the slider. im talkin about when you hit select then the left cursor key. sometimes when i do this on the end feild it jumps the end way far up, near the start of the sample, sometimes i dont even have to hit the cursor buttons, if i hold shift for like 3 seconds itll do it.

No mines never does it and never has.

On another note:
Slider chopping sucks
 Reply
Return to MPC2000xl, MPC2000