Technical questions for the MPC2000xl and the MPC2000
User avatar
By four eyes Tue Oct 21, 2008 12:05 am
which do you prefer using? i had a scsi zip drive but since i just recently fell victim to "the click of death". i pretty much will not use an external drive anymore.

i've been using floppies and i've grown quite fond of them. not much space in them, but if you get creative by saving your sounds mono or at a lower bit rate you cant fit quite a lot onto one disk.

i'm pondering putting a CF reader though. are they pretty reliable compared to the other methods of saving and loading?
User avatar
By Lampdog Tue Oct 21, 2008 12:38 am
2kxl internal cf, and/or scsi hd. Can't beat it.

2k, scsi external cf, and/or hd. Can't beat it.

There are no moving parts to get worn out in card readers so they are pretty damn good with longetivitiy.
By distantb Wed Oct 22, 2008 8:01 pm
I like keeping the internal floppy with external zip. Best of both worlds. I still like to use my old floppys from my 60 if i didnt have those i wouuld be all zip.
By pakkman6 Mon Oct 27, 2008 10:44 pm
scsiforsamplers.com wrote:If I may add one more option to what Lampdog said - we now have an internal SCSI CF card reader drive and install kit for the MPC2000, so internal is an option as well. It is super easy to install - no soldering - and takes about 15 minutes. The external SCSI port stays active, btw.

where can i find this card readed at? i seen them on ebay a while ago for about $125.00..but now they arent on there
User avatar
By four eyes Wed Oct 29, 2008 2:00 am
how do those internal scsi card readers work i dont get it. you can connect to scsi from the inside? and what about the outside scsi port?

it'll still works?
By scsiforsamplers.com Wed Oct 29, 2008 2:17 am
We have an internal cable kit that allows you to hook up the internal SCSI drive and still keep your external SCSI port active. It is simple to install and requires no tools other than a screwdriver. Installation instructions are included.

Kits are available for the MPC60 and MPC3000 - these are the sampler models which don't have an internal SCSI connection.

The special kit isn't needed for models like the MPC2000XL or S5000/S6000 - those units have an internal SCSI connector and the internal card reader drives can be hooked up with a simple ribbon cable (which we include with the drive).
Last edited by scsiforsamplers.com on Wed Oct 29, 2008 10:39 pm, edited 1 time in total.
User avatar
By dj_evs Wed Oct 29, 2008 10:45 pm
After years of using an external zip100 I finally purchased and installed the CF reader. It has some minor glitches, but I managed to save 12 full zips onto a 2gb card. No loose cables out the back, no complaints. The unit is nice as one piece.
User avatar
By four eyes Thu Oct 30, 2008 3:31 am
ya i just put a really cheap reader in a couple days ago.

should done it a long time ago.