By BassLINE
Fri Jul 02, 2004 3:46 am
elmacaco wrote:Cool, definitly do that!
IF it's an HD drive it should be fine, but you must use HD disks, if no, use the DD's only, a guy on the 60 yahoo group just lost his floppy because of using HD floppies.
Glad that helped.
I highly doubt it was because he was using HD floppies that his drive died.
Quote from Akai MPC 60 Sofware Version 3.1 manual:
Comment: DS/DD disks are becoming difficult to obtain because of the greater popularity of high-density disk (HD). If you can't find any DS/DD disks, HD disks instead will work fine in the MPC60. However, if you take an HD floppy that has been formatted in the MPC60 and try to read it in an MPC3000, the MPC3000 will tell you that the disk is bad or not formatted. If this happens, simply cover the HD hole in the lower right corner of the disk with opaque tape. (This hole is located on the same edge of the disk as the "HD" emblem, and unlike the other "write protect" hole, has no sliding window.) This will trick the MPC3000 into thinking that the floppy is a DS/DD disk and will then be able to read it.

