Selecting all files in program mode

This may be an obvious questions, but I checked the manual and I couldn't figure out how to select all the files in program mode and apply filters or tune all the samples at once without having to do each individually. Any help would be greatly appreciated. Thank you! Keep makin them classics!

http://www.jchopbeats.com

maybe you didn't find it in the manual cause it can't do it.

maybe I'm wrong.

as far as i know.... that can not be done. effects and filters are assign on a per pad basis. there isn't a global select feature.

Is there a way to do this in Bluebox? I cant figure it out...
I want to change the decay on all the pads at the same time..

soyo wrote:Is there a way to do this in Bluebox? I cant figure it out...
I want to change the decay on all the pads at the same time..

to my knowledge... no but i think something like this may be coming to bluebox. PM wasageis and ask him.

soyo wrote:Is there a way to do this in Bluebox? I cant figure it out...
I want to change the decay on all the pads at the same time..

I believe you can. I think this applies to any setting you make in bluebox. After you change the setting on 1 pad, RIGHT click on the setting you just changed and you should be able to select "setting..." then "apply to pads..." and then you can select which pads to apply that setting to.