quick question about cross/upgrading jjos?

ok so after a quick fling with the 500 i had the chance at a cheap 1000 and took it, it came with jjos2 but i have since installed jjosfree as a place to start but i wondered if anyone can advise if i go on to update to jjos2xl whether the process would recognize that jj0s2 was at some point installed?
is the registration machine specific?
sorry for the boring q
JJ

Digger65 wrote:ok so after a quick fling with the 500 i had the chance at a cheap 1000 and took it, it came with jjos2 but i have since installed jjosfree as a place to start but i wondered if anyone can advise if i go on to update to jjos2xl whether the process would recognize that jj0s2 was at some point installed?
is the registration machine specific?
sorry for the boring q
JJ

Can you put back os2 and make sure you can save?

hi thanks
yeah that makes sense
will give it go tomorrow and update post
being Fri13 n all
what could possibly go wrong..

just to clarify should i load OS1 then OS2 both via CF card
or better to load OS2 straight via USB?
thanks again

Your JJOS2 password is stored permanently in your machine, nothing can remove it (unless you replace the main board!), so you can feel free to install any other JJ versions in any order you want, and can revert back to OS2 at any time.

Any problems (incredibly unlikely), contact JJ, he'll have a record of your unit's unique hardware code so can verify the original OS2 purchase.

MPC-Tutor wrote:Your JJOS2 password is stored permanently in your machine, nothing can remove it (unless you replace the main board!), so you can feel free to install any other JJ versions in any order you want, and can revert back to OS2 at any time.

Any problems (incredibly unlikely), contact JJ, he'll have a record of your unit's unique hardware code so can verify the original OS2 purchase.

That's good to know!!