Mpc 2000 circuite diagram?

Cursors configuration.
I recently replaced all my tact switches.
But kind of made a mess of the 4 cursor key part .
Anybody got a photo of that part of the ciruite board?
I'v bought a magnifying glass as I think I went in a bit brutish last time and burnt out the contact trace.
Bit of a long shot but, anyone have a picture of how that part of the circuite should go?
Apriecate any advice.
Peaaace : ))))))))

Here is the MPC2000 service manual for you to peruse through... https://www.mpc-tutor.com/files/mpc-service-manual/MPC2000_ServManual.pdf

Service Manual of the 2000 doesn't have a drawing of the circuits.
Last time I opened (and then closed) my 2000 I forgot to install the cable fom the 8out board. I will install it tomorrow and make a photo of the circuit board.

peace

I have them. How can I attach them to this post? (So they can be available for everyone)

You can find them here
https://home.hccnet.nl/ray.ray/MPC2000/CircuitDiagram/

RoxyRoxtar wrote:You can find them here
https://home.hccnet.nl/ray.ray/MPC2000/CircuitDiagram/

Thank you for sharing this. I also see you've been researching the LCD at some point, how did that work out for you?

richie wrote:

RoxyRoxtar wrote:You can find them here
https://home.hccnet.nl/ray.ray/MPC2000/CircuitDiagram/

Thank you for sharing this. I also see you've been researching the LCD at some point, how did that work out for you?

I started my research recently but I don't know if its worth to proceed. The data aqcuired with my logic analyser must make sense, otherwise I stop.

Im not sure if the (P)Seiko/Epson collaboration is equivalent to the KS-110, the KS-110 chipset is like a ghost.
I hope what I found is what is being used in the MPC.

RoxyRoxtar wrote:Im not sure if the (P)Seiko/Epson collaboration is equivalent to the KS-110, the KS-110 chipset is like a ghost.
I hope what I found is what is being used in the MPC.

Considering it is serial data at that point, it would be pertinent to look into the same / similar serial conversion used in all 3 previous "new age" solutions.

The only on record display I've found for the Seiko displays was 248x60 instead of 256x64 which is what the actual MPC lcd is.

RoxyRoxtar wrote:You can find them here
https://home.hccnet.nl/ray.ray/MPC2000/CircuitDiagram/

Hi,
I would like to access to your Mpc 2K schematics but access is forbidden. Is there a way to dowload them?

Best regards.

There are no mpc2000 classic schematics available, nowhere, even paid.

You will find the 2000xl ones in google.

What's the problem with your unit?