Try Zooming in on the Sample End, and activate the Snap Function, then Scroll the End Marker a Smiggian. Then Play with the Release Envelope of the the Sample.
Or if you're on 2.10 play with the Tail Length Function on the Program Edit (Sample Tab) screen
By 40Beatz
Mon May 09, 2022 7:42 pm
I think like a MPC. A program is a tool. If the sculpture don't look right, Don't blame the chisel..
MPC5000, MPC4000, MPC3000, MPC 2500, MPC 2000XL MPC X/LIVE 2/3/ONE
MPC5000, MPC4000, MPC3000, MPC 2500, MPC 2000XL MPC X/LIVE 2/3/ONE
By handthrow
Tue May 10, 2022 6:10 am
You can also record a video of it so we'll se what's going on
By Lampdog
Tue May 10, 2022 8:52 pm
40Beatz wrote:Try Zooming in on the Sample End, and activate the Snap Function, then Scroll the End Marker a Smiggian. Then Play with the Release Envelope of the the Sample.
Or if you're on 2.10 play with the Tail Length Function on the Program Edit (Sample Tab) screen
THIS.
POPS and CLICKS happen because of a waveform not ending on a zero point and/or sudden drop/increase in volume. Inexperience is a big factor in this. The more you understand zero crossings, waveforms, envelopes the easier wave editing gets. All goes back to what 40Beatz said above.
Stop getting automatically offended when you see gold letters!
By 40Beatz
Wed May 11, 2022 1:08 pm
I've Been Blessed By Lord Lamp
I think like a MPC. A program is a tool. If the sculpture don't look right, Don't blame the chisel..
MPC5000, MPC4000, MPC3000, MPC 2500, MPC 2000XL MPC X/LIVE 2/3/ONE
MPC5000, MPC4000, MPC3000, MPC 2500, MPC 2000XL MPC X/LIVE 2/3/ONE