Discuss the various methods you use in music production, from compressor settings to equipment type.
User avatar
By jahrome Sat Nov 12, 2005 8:50 pm
I am curious to know how and why every here is placing their mics for vocal recording.

Are you placing it right side up where the mic is level with the performer...

Or are yoyu placing it upside down where the performer is singing/rapping up into the mic?
Last edited by jahrome on Sat Nov 12, 2005 9:35 pm, edited 1 time in total.

By fader-pro Sat Nov 12, 2005 9:08 pm
If you put the mic upside down the vocals come out backwards....but dont worry...if you then play the recording backwards while standing on one foot it should all work out :lol:

By fader-pro Sat Nov 12, 2005 9:12 pm
Your vocalist will have a tad more power with his chin up a bit but whatever is comfortable is best. Just make sure the mic is not too close and don't allow your vocalist to sing directly into it as you will get pops on the P's & B's....I typically position the vocalist about 8 - 10 inches behind the mic and 2 inches or so to the side...rightside up or upside down no difference. Invest 20 bucks in a pop filter and stand or just make one out of a coathanger and some stockings....
User avatar

By DSTRUCT Sat Nov 12, 2005 11:56 pm
i use a dynamic mic so i set it up basically horizontal, pointed directly at the artist, some times ill aim it more down toward the artist, if it brings a better performance out of them to have they chin up.
User avatar

By Lampdog Sun Nov 13, 2005 1:14 am
I have a boom type mic stand. I have the mic upside down slightly tilted toward the upper lip of the emcee. It makes them tilt their head up a little so the airway opens more. I've had better results that way.
User avatar

By Yoshimi Sun Nov 13, 2005 12:19 pm
Lampdog wrote:I have a boom type mic stand. I have the mic upside down slightly tilted toward the upper lip of the emcee. It makes them tilt their head up a little so the airway opens more. I've had better results that way.


Good advice.
By Eemo1 Sun Nov 13, 2005 12:32 pm
tube mics should be placed upside down so the heat from the tube doesn't **** up the capsule.

tube mics 101.