how to hook up a turn table to a MPC 2000

Thanks Eric Sokol. Maybe you can help me with one more problem. I've got the RCA dual mono 1/4 in cable but can't hear anything from when I'm on sample mode on the mpc. Any advice?

im guessing u mean u got a turn table hooked directly to the mpc? if so you might need to hook it up to a mixer.. try turning the theshold to 0 and turning the rec gain up if not it might be the cables

you dont have to use a mixer,there are even small boxes for sale you can put your cinch cable in and get a amplified signal out at the other side.this device has no knob or fader to change the volume it just amplifies the signal.the trim should be done in your mpc.might cost about 15 dollars....

should questions like these be banned from a forum for technical questions????
this is soooooooooooooooooooooooooooooooo basic....basic as f&%$§§$%

small box that amplfys the signal must be something cool i never heard about

Eric Sokol wrote:small box that amplfys the signal must be something cool i never heard about

dont know if its available in the us... but in germany...
maybe the voltage keeps you from that...would send a photo,but its only a black box....the rest is your fantasy---go!

haha this sounds cool is it like a pre amp?

Ok...... For my and everyone elses sanity....

This Thread should be CLOSED.


1. If you are running PHONO OUTS, then you need a preamp. Or a MIXER that will do the same thing.

2. If you are running a table that has LINE LEVEL outs, then go straight to your RECORD IN jacks.

3. If you don't use a MIXER or LINE OUT TURNTABLE, then you need a standalone PHONO PRE-AMP.

4. If you ask any more ridiculous questions like this again, I will start a petition to have you mocked from every angle possible, for the remainder of your life as a forum member...

I appreciate the naivety of your question, however, this is hardly a relevant question. do some homework buddy, and save the rest of us the stress of reading and answering amazingly simple shit.

Peace

~Grub

man cmon these boards are to help ppl..how happy were you when u first started sampling i know i was **** trilled. yeah it is common sense shit but some ppl first get there mp and look at it like is a document written in chinese or some shit not realizing most of the shit on it is common trail and error shit...yeah u should read thge manual and at least try to do simple shit on your own but some people are kinda threatend by the mpc monster

Then post it in the Getting Started section, don't do it here.

yeah,must be,didn t it??

Eric Sokol wrote:haha this sounds cool is it like a pre amp?

yeah,found a photo of the cheapest and smallest preamp out there..................... http://cgi.ebay.de/ALESIS-M1-ACTIV-520- ... dZViewItem
naah,check below....